Tiling is one job that most people would rather not learn how to do since it can be scary that you may make some mistakes in the process. However, it is actually a lot easier than what many might think. In fact, it can save you a whole lot of money in contrast to hiring a professional for the job. As long as you know the do’s and don’ts then this task is a no-brainer for you.
To start off, you have to choose the tiles that you want to use. Tiles come in different sizes, colors, textures, materials and finishes. It can also depend on how you want the room to be and the overall design and feel of the room.
You will need to measure out your floor area. You will also have to deliberate on whether you want the tiles to go under any kind of fittings and units. Generally, it is better if you tile under the fittings. This is recommended so that if you have to move appliances in the future, like a fridge, then you do not have to lift it up and over the edge of your new tiles.
Be sure that you have an even coverage of adhesive placed on your sub-floor. The type of adhesive to use would depend on your sub-floor or the surface you are tiling. If it is a concrete floor, then you can use a rapid setting adhesive. However, be sure that you do not spread too much of the mixture at once, since it can set in as fast as 30 minutes.
If it is a wooden sub-floor, then you need a flexible adhesive. The bag or tub should say if the adhesive is flexible. If you have slate, then you need to use gray adhesive. If you’ll be using marble, then you need a white adhesive. This is so that no color coming from the underside would bleed and ruin your design.
When you are done fixing your tiles on the floor, and after you have allowed enough time for it to dry, then you will have to do some grouting. If you have natural tiles, like marble, slate, limestone, granite, travertine, and porcelain, you need to seal them first before you can grout them. You have to use a specialized impregnating sealer so that they will be waterproof and can be more resistant to dirt and staining.
Mix up the grout and apply it using a grout float to your tiles. Try to work over the gaps until they’re all filled. If you have white marble tiles, then you need to use a white grout instead of gray since the gray kind can stain the marble.
To finish off, wipe out the excess grouts that are bulging from your tiles using a sponge. Also, use a grout finisher or your finger to smooth out the grout lines. After this, stand back, relax as you wait for your work to dry up!